Gutter Installed Over Drip Edge

A gutter apron is installed on the corners above roof decking.

Gutter installed over drip edge.

If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. Generally they want it installed so that the drip edge must go over the underlayment and then be cemented to the shingle s starter course and or tar paper. The roofer installed the drip edge tight against the fascia. If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter.

If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. The best practice is to always install the drip edge so that it is inside the gutter. A gutter apron is used where shingles are not far enough from the edge of the gutter. Does the gutter go under over or behind a drip edge.

The whole purpose is to direct the water into the gutters. The drip edge not only safeguards you from potential damages but it also preserves the appearance of your roof. Use tin snips to cut the gutter apron flashing roll in two 3 in. The gutter is installed right under the drip edge which is tilted purposely.

Posted by everything gutter on sep 15 2015 in downspouts gutter cleaning gutter guards gutter repair gutter sagging ice dams leaky joints leaky seams new gutters seamless gutters seamless rain gutters comments off on does the gutter go under over or behind a drip edge. While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter. It is put under the shingles of an attic to flow water directly into the gutter. So the rainwater flows into the gutter and out of it through downspouts attached along the wall and away from the house.