It is intended to give you a good idea of the steps involved when installing an emoc storm and screen door.
Installing screen panel into storm door.
It should not go in between the screen and the door frame.
Get installation instructions for your storm door including preparing the rough opening sealing shimming fastening flashing and water management.
Insert the retainer strips in place.
Begin the project by folding open the box and removing the glass storm panel.
There is a separate piece of spline for each side of the screen.
Remove the glass and place the screen in the door opening.
Window screen hanger latches finish mill stamped aluminum used to install 7 16 inches window screens to wood framed windows will install 2 window screens.
Use this measurement to mark the appropriate point on the hinge side z bar with a pencil then use your hacksaw to cut.
Complete the installation by installing the door closer.
Screw the bolts back into the door and you are finished.
Pull the splines out of the door frame groove with steady firm pressure.
Position the sweep so its weather stripping touches the sill and screw into place.
Install the handle set and associated hardware of the new door lock.
If you chose to install a new window the process is very straightforward.
Slide the expander off the bottom of the door and install the sweep.
Slide it into the door channel in front of the screen.
10 80 14 94 6 12 18 24 30 36 42 48 54 60 66 72 78 84 90 96 102 108 114 120 126 132 138 144 150 156 162 168 174 180 186 192 198 204 210 216 222 228 234 240 246 252 258 264 270 276 282.
This is not an instructional video.
Use a nut driver or a screwdriver if needed and unscrew the window that is currently on the storm door.
The splines are pieces of narrow rubber tubing that keep the screen secure around the door frame.
Replace it with the new one that has the screen insert already installed.
Use an awl or your screwdriver to pry up the spline at the corner of the frame.
Pick a flat area near the entry door lay the box flat on the ground fold it open and check to make sure you have all the parts.
Step 3 remove window panes.
Start at the top of the door and hold the retainer at about a 45 degree angle with the edge with writing on it facing you.