Make sure the screws aren t exposed.
Installing trim around sliding glass door.
Place a piece of threshold trim available at the flooring supplier next to patio doors or similar thresholds where you need to stop the laminate flooring.
Replacing sliding glass doors.
Nail the cap and shoe.
Use expanding foam insulation to seal any gaps between the door frame and wall.
Secure the first piece with your carpentry nails.
Nail up the large base photo 13.
In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.
Trim with a 1 8 inch gap after the flooring has been laid.
Step 3 install.
Threshold molding can be reused on sliding gl.
Use a putty knife to remove the excess.
Secure the threshold to the door with screws.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
Measure the lip of the threshold s trim and leave enough clearance between the door and the flooring to install the threshold.
Replacing sliding glass doors.
Cover the foam insulation with trim and add a small amount of caulk to the visible joint.